DS18B20
Komponen

DS18B20

4.5(4)
8
The DS18B20 is a digital temperature sensor that can measure from -55°C to +125°C with an accuracy of ±0.5°C. The most prominent feature is the waterproof probe version, so it can be used safely for liquid temperature measurement and in humid environments. It uses the Wire protocol, which communicates over a single data line, and it is possible to connect multiple DS18B20 sensors together on the same line to read independent temperature readings from each one. It is frequently preferred in applications such as aquarium, water heating system and soil temperature monitoring.

Projek yang menggunakan komponen ini

Raspberry Pi Pico Tea Thermometer (DS18B20 + TM1637 + Buzzer)
PI-33Pertengahan
Premium

Raspberry Pi Pico Tea Thermometer (DS18B20 + TM1637 + Buzzer)

Let the Pico tell you when your tea is ready to drink! We are building a thermometer with a Raspberry Pi Pico that measures the tea in your glass. A waterproof DS18B20 probe goes into the tea, and a TM1637 display shows the temperature and the time left until it is drinkable. At 65 degrees the buzzer plays a tune, and it warns you if the tea gets cold.

ESP32 Wi-Fi Water Heater Temperature Control: Phone Alert When the Hot Water Is Ready (DS18B20 + Relay + LCD + ntfy)
ES-89Pertengahan
Premium

ESP32 Wi-Fi Water Heater Temperature Control: Phone Alert When the Hot Water Is Ready (DS18B20 + Relay + LCD + ntfy)

Water heater temperature control with an ESP32: a DS18B20 measures the water and a relay switches the heater on at target − 3 °C and off at the target. ECO, NORMAL and SHOWER modes plus + and − buttons set the target, and your phone gets a "su hazir" (hot water ready) alert. Overheating, a dead sensor or a heater that won't heat cut the relay at once. 230 V warning: the relay drives a contactor; a breaker, an RCD and a licensed electrician are a must.

Raspberry Pi Pico W Window Left Open: The Heating Runs for Nothing (DS18B20 + LED + Buzzer + ntfy)
PI-87Pertengahan
Premium

Raspberry Pi Pico W Window Left Open: The Heating Runs for Nothing (DS18B20 + LED + Buzzer + ntfy)

A Raspberry Pi Pico W watches the room temperature with a DS18B20 and spots a window left open by how fast the room cools: if it drops 1 °C within 3 minutes, the buzzer sounds an alarm, the LED blinks and an ntfy notification reaches your phone. When the window is closed the room warms up again; the code catches that and reports how many minutes it was open. The slow cooling of a night setback gives no alarm.

Homemade Yogurt Maker: 8 Hours at 43 °C (Arduino + DS18B20 + PID)
AR-159Mahir
Premium

Homemade Yogurt Maker: 8 Hours at 43 °C (Arduino + DS18B20 + PID)

A waterproof DS18B20 measures the milk, and a PID loop drives the relay in a time window to hold the heater at 43 °C. Once the temperature reaches the target, an 8-hour countdown starts. The I2C LCD shows the temperature, the PID output and the time left, and the buzzer sounds when time is up. Two buttons set the target (38-46 °C) and the duration (4-12 hours). Active-low relay handling, sensor fault and overheat protection are in the code.