Electret Microphone
Komponen

Electret Microphone

0.0(0)
An electret microphone is a two-leg capsule in a metal can that turns sound into a small electrical signal. Inside there is a thin diaphragm and a tiny transistor (JFET) that passes the signal on, so it does not work without a supply. It has polarity: the leg tied to the metal case is the minus leg and goes to GND; the other leg is plus and connects to the positive rail through a resistor, usually 2.2 kΩ to 10 kΩ. The audio signal is taken from this plus leg through a capacitor. Common 9.7 mm capsules run from 3 to 10 V and draw at most 0.5 mA; check the datasheet of your own capsule for exact values. The signal is very small, only a few millivolts even when you speak close to it, so it cannot drive an LED or a logic input directly; a transistor or op-amp stage amplifies it first. It picks up sound from every direction, and sudden sounds and air movement such as blowing, a clap or a knock on the table give a much larger signal than speech. Unlike sound sensor modules such as the KY-038 it is a bare part with no comparator board.