Teroka Projek Arduino
Ratusan projek dari pemula hingga mahir: gambar rajah litar, kod dan video. Mulakan di tahap mana pun kamu berada.

ESP32 Frost Alarm: Will the Windshield Freeze Tomorrow Morning? (DHT22 + I2C LCD + 2 LEDs + Buzzer)
No more scraping the car window at 7 am: the DHT22 measures outdoor temperature and humidity, the ESP32 works out the dew point and tells you whether the windshield will freeze tonight. The I2C LCD shows temperature, humidity and dew point; green LED means SAFE, blinking red RISK, steady red plus a buzzer alarm FROST. If the air cooled fast in the last hour, it warns you about the night too.

ESP32 Wi-Fi Water Heater Temperature Control: Phone Alert When the Hot Water Is Ready (DS18B20 + Relay + LCD + ntfy)
Water heater temperature control with an ESP32: a DS18B20 measures the water and a relay switches the heater on at target − 3 °C and off at the target. ECO, NORMAL and SHOWER modes plus + and − buttons set the target, and your phone gets a "su hazir" (hot water ready) alert. Overheating, a dead sensor or a heater that won't heat cut the relay at once. 230 V warning: the relay drives a contactor; a breaker, an RCD and a licensed electrician are a must.

ESP32 Snowball Fight: Two-Player Matrix Game (8x8 NeoPixel + 4 Buttons + Buzzer)
A two-player snowball fight for the winter break on an 8x8 NeoPixel matrix. Blue on the left, red on the right, both behind an ice wall. The THROW button sends a snowball flying in an arc, the DUCK button hides you behind the wall. Balls that meet in the air burst, and every round has its own wind that speeds balls up or slows them down. Lose 3 lives first and you lose; the winner gets falling snow and fireworks, with throw, hit and victory sounds from the buzzer.

ESP32 Moon Phase Lamp: What Does the Moon Look Like Tonight? (DS1307 + 8x8 NeoPixel + Button)
A night lamp for your desk that draws tonight's moon: an 8x8 NeoPixel matrix shows a crescent, a quarter, a gibbous or a full moon. The DS1307 keeps the date, and the ESP32 counts the phase from a known new moon and corrects it with Meeus' terms to within a minute. One button switches between today, days to full moon and a whole month played in 8 seconds. 24 December 2026 is the last full moon of the year.

ESP32 Tank Duel: Two Player Retro Game (ILI9341 TFT + 2 Joysticks + Buzzer)
A two player tank duel on a color TFT screen, in the style of the two player tank games of the 80s. Each player drives a tank in 8 directions with a joystick and fires by pressing the stick down. Bullets bounce 3 times off the walls: you can hit a rival hiding behind a corner with a bank shot, but your own bullet can come back and hit you too. A tank that is hit explodes and the rival scores 1 point; first to 5 points wins. Score at the top, sounds from the buzzer.

ESP32 Firefly Jar: Lights That Fall Into Sync on Their Own (8 LEDs + Button)
The 8 LEDs in the jar are fireflies: they flash at random first, and a few minutes later, with nobody telling them, all of them flash at once. There is one rule: a firefly that sees a neighbour flash moves its own clock a little forward. When sync arrives the jar glows for 3 seconds. A short press of the button shakes the jar and scatters them; a long press stops them seeing each other. In the fast version in the video sync takes 11 seconds. No PWM, no library.

ESP32 Sunrise Alarm Clock: Wake Up Gently with Light (DS1307 + LED Ring + LCD)
Getting up in the dark on a winter morning is hard. 20 minutes before the alarm this clock slowly lights a 24-LED ring from the bottom up: deep red first, then orange, warm white at the end. At alarm time the buzzer plays birdsong. The PLUS button snoozes for 5 minutes, the SET button silences it. A battery-backed DS1307 keeps the time and the alarm is stored on the board, so neither is lost in a power cut. The LCD shows the time, the alarm and the sunrise percentage.

ESP32 Fall Alarm: Notifies the Family if Nobody Answers (MPU-6050 + Button + Buzzer)
Worn on a belt or in a pocket, this device uses an MPU-6050 to catch a sudden impact followed by stillness. Once that counts as a fall it counts down 30 seconds: the buzzer beeps and the LED blinks. Pressing the I am OK button in that time cancels the alarm. If nobody presses it, a siren sounds and the ESP32 sends a notification to the family's phones over Wi-Fi with ntfy. Made for icy winter days and relatives who live alone; the siren works even without internet.

ESP32 Plank Coach: Beeps When Your Hips Drop (MPU-6050 + I2C LCD + Buzzer)
An MPU-6050 taped to your back watches the angle of your body while the ESP32 counts your plank time on the LCD. If your hips drop it warns with low beeps, if they rise with high beeps, and the time pauses right there; fix your form and it carries on. Fail to recover within 3 seconds and the plank ends with your time on the screen. Your best time is stored on the board as the record and survives unplugging. An honest training partner for a New Year fitness resolution.

ESP32 Light Trail Duel: Two Player Retro Game (16x16 NeoPixel + 4 Buttons + Buzzer)
Two light bikes race across a 16x16 NeoPixel matrix without stopping and leave a glowing trail behind. Each player has two buttons: one turns the bike left, the other right. Hit a trail, the rival or the edge and you lose the round. The bikes speed up as the round goes on and the room runs out; the first to win 3 rounds takes the match. Score on the matrix, sounds from the buzzer. A two player duel in the style of the 80s trail games, made for New Year's Eve.

ESP32 New Year World Tour: Where Is 2027 Right Now? (NTP + I2C LCD + 24 LED Ring + Buzzer)
The new year does not reach the whole world at once: it starts on Kiritimati in the Pacific and travels west for 26 hours. This build follows that wave live. The ESP32 gets the time from the internet (NTP); whenever the new year enters one of 24 stops, one LED on the 24 LED ring lights up, the buzzer chimes and the LCD shows the city. The bottom row counts down to the next city. At the last stop the ring turns into a rainbow.

ESP32-CAM Wi-Fi Live Camera
A live camera on your phone with a palm-sized board: the ESP32-CAM joins your home Wi-Fi and serves its own web page. Type the address from the Serial Monitor into your phone's browser and the live picture (MJPEG stream) appears. A button on the page turns the on-board flash LED on and off, and a list picks the resolution from 320x240 up to 1280x720. You upload the code with a CH340 USB-TTL adapter; one jumper between IO0 and GND while uploading is all it takes.
