74HC14 Schmitt Trigger NOT Gate
Komponentlar

74HC14 Schmitt Trigger NOT Gate

0.0(0)
The 74HC14 is a 14-pin (DIP-14) logic IC that contains six Schmitt-trigger NOT gates (inverters). Each output is the inverse of its input; the difference from the 74HC04 is that the input has two separate thresholds. A rising input switches the output only at the upper threshold, a falling input only at the lower one. At 5 V these thresholds are roughly 2.8 V and 1.7 V; the gap between them is called hysteresis. The thresholds vary widely between parts. Thanks to this, a slowly changing or noisy signal does not make the output chatter. The pinout is the same as the 74HC04: the first gate's input is pin 1 and its output is pin 2; pin 14 goes to the supply (VCC) and pin 7 to GND. It runs from 2 to 6 V, so put a 5 V regulator in between when you use a 9V battery. Do not leave unused inputs floating: tie them to GND or VCC. You can drive an LED from an output through a 1 kΩ resistor. It is used to build a square-wave oscillator from one gate, a resistor and a capacitor, to clean up switch bounce and to sharpen signals with poor edges.