LM358 Op-Amp
Komponentlar

LM358 Op-Amp

0.0(0)
The LM358 is an 8-pin (DIP-8) chip with two independent op-amps. It runs from a single supply between 3 and 30 V, so a 5 V breadboard power module or a 9 V battery can feed it directly. Pins: 1 output A, 2 inverting input A, 3 non-inverting input A, 4 GND, 5 non-inverting input B, 6 inverting input B, 7 output B, 8 positive supply. The inputs read voltages from GND up to about 1.5 V below the positive supply; because the range reaches GND, it suits sensor circuits. At least one input must stay inside this range. The output gets very close to GND but cannot reach the positive rail: on a 5 V supply it goes up to about 3.5 V. The output typically sources 30 mA and sinks 20 mA; for a buzzer, a relay or several LEDs, put a transistor in between. It is used as a comparator that tells which of two voltages is higher, and in amplifier, oscillator and filter circuits. Do not leave the unused half floating: connect its non-inverting input to GND and its output to its own inverting input. Put a 100 nF capacitor next to the supply pins.