AR-13Boshlang‘ich

Using a Buzzer

4.7(92)
171 bajarildi
Using a Buzzer
Ever wondered how a doorbell or an alarm makes its sound? The Arduino makes a small buzzer beep at short intervals: beep, pause, beep, pause. You see how sound is made with electricity and take the first step toward projects that play whole melodies.

Video

Elektr sxemasi

Using a Buzzer - Elektr sxemasi

Manba kodi

C++ (Arduino IDE)
1// ─────────────────────────────────────────
2//   BlueGrays · bluegrays.com
3//   Using a Buzzer
4// ─────────────────────────────────────────
5// The buzzer beeps at 400 Hz for 0.3 s, stays silent for 0.3 s and keeps
6// repeating. Shows how to use tone() and noTone().
7//
8// Pins:
9//   D7 -> Buzzer + (other leg to GND)
10
11int frequency = 400;   // Tone frequency (Hz)
12int buzzerPin = 7;     // Buzzer output pin
13
14void setup() {
15  // tone() sets the pin as an output itself
16}
17
18void loop() {
19  tone(buzzerPin, frequency);   // Start the 400 Hz tone
20  delay(300);
21  noTone(buzzerPin);            // Stop the sound
22  delay(300);
23}
24

Ko‘p so‘raladigan savollar

What is the difference between an active and a passive buzzer?

An active buzzer contains an oscillator; it produces a constant tone only when a voltage is applied. A passive buzzer requires an external frequency source; it can play different notes using the `tone()` function. Passive buzzers are required for melody projects.

How do you use the tone() function?

tone(pin, frequency) plays a sound at the specified frequency; noTone(pin) silences it. A duration can also be specified using the format tone(pin, frequency, duration). For example, 440 Hz is the note A.

The volume is very low. How can I turn it up?

The Arduino pin drives the buzzer with a limited current. For a louder sound, you can drive the buzzer through an NPN transistor (e.g., BC547) or choose a configuration that doesn't block the buzzer's hole.

Will using `tone()` cause problems on the other pins?

In Uno, the `tone()` function uses Timer2; therefore, PWM (analogWrite) does not work properly on pins 3 and 11 while it is playing. If you need PWM at the same time, select different pins.