Arduino loyihalarini kashf qil
Boshlang‘ichdan yuqori darajagacha, sxemali, kodli va videoli yuzlab loyihalar. Qaysi darajada bo‘lsang, o‘sha yerdan boshla.

ESP32 Automatic Cat Toy (PIR + 2 Servos + LDR + Buzzer)
Keep your cat busy while it is home alone! When the PIR sensor spots the cat, the buzzer chirps like a bird and a feather wand on two SG90 servos moves like prey: mouse dash, hide and seek, zigzag, circle and bug jitter. A game lasts one minute, then the toy rests; when the LDR sees darkness it never plays at night. The moves come from the ESP32's hardware randomness, so the cat cannot learn them.

ESP32 Robot Dog That Sees You: Wags Its Tail and Barks (HC-SR04 + 2 Servos + Buzzer)
A robot dog that sleeps and snores when nobody is around, then wakes up when you reach out and tilts its head to say hello. The HC-SR04 is its eyes: the closer you get, the faster the tail servo wags, and under 15 cm it barks "woof woof". Walk away and it waits, then sulks: the head servo turns away and the buzzer sighs. Come back and it can't contain its joy. All built on a state machine, a median filter and non-blocking timing.

ESP32 Baby Cradle Rocker (Servo + I2C LCD + 2 Buttons + Buzzer)
A helper for tired parents: an SG90 servo rocks a toy cradle with a soft, sine-like swing while a buzzer quietly plays Brahms' Lullaby. Two buttons give you 3 speeds (SLOW, MEDIUM, FAST), lullaby on/off and a 10, 20 or 30 minute timer, and the I2C LCD shows the mode and the time left. When time is up the cradle never stops dead: the swing fades out slowly and the lullaby slows to its end.

ESP32 Blooming Tulip Lamp: Opens at a Touch (Servo + 24 LED Ring + TTP223)
The maker world's favourite blooming flower lamp, with a Tulip Era twist: touch the TTP223 sensor and an SG90 servo slowly opens the petals on a soft speed curve while a 24 LED ring fades in from darkness. While it is open, every touch changes the colour: red, purple, yellow, warm white and a tulip garden that drifts around the ring. Hold it and the tulip closes as the light fades out.

ESP32 Bluetooth Car (L298N)
Drive a two-wheel car over Bluetooth with the joystick on your phone; no internet needed, works on iPhone and Android. This project is the step-by-step guide to the Car remote Bluetooth template in the app, built with an ESP32, an L298N and two motors. Go to Workshop › Devices › Add a device › Bluetooth, pick Car remote and upload the code from Get the code. The Set up as a Bluetooth panel button on this page opens the wizard with this template.

ESP32 Bluetooth Servo Lock
Control an SG90 servo as a small latch from your phone over Bluetooth: lock, open or set the angle, no internet or Wi-Fi needed. This project is the step-by-step guide to the Servo lock Bluetooth template in the app, built with an ESP32, one servo and 3 wires. Go to Workshop › Devices › Add a device › Bluetooth, pick Servo lock and upload the code with Get the code. The Set up as a Bluetooth panel button on this page opens the wizard with this template too.
