ES-54PertengahanPremium
ESP32 Egg Incubator Controller (DHT22 + Relay + Servo + OLED)
Hand the hen's job to an ESP32! The DHT22 measures temperature and humidity, a relay switches the heater with hysteresis, an SG90 servo gently tilts the egg tray every 3 hours, and the 0.96 inch OLED shows the day counter, a temperature graph and alarms. Chicken, quail and duck profiles are built in, and turning stops by itself for the last 3 days. If the sensor fails, the heater switches off for safety.
0.0(0)

Let a small box do the hen's job: it keeps the eggs warm at about 37.7 degrees, the usual figure for chicken eggs, watches the humidity and gently tilts the tray every three hours to turn them. The screen shows the temperature, the humidity and which day you're on, and turning stops by itself in the final days. If something goes wrong it sounds an alarm, and even after a power cut the day count picks up where it left off.
Relay note: This board runs on 3.3 V. Use a relay module with an optocoupler that can be triggered by a 3.3 V signal; 5 V modules without an optocoupler may not switch off with a 3.3 V signal.
Kod Sumber
Kandungan Premium
Kod sumber, versi blok dan soalan lazim projek ini terbuka untuk ahli Premium.
- Semua Kod Projek
- Versi blok
- Soalan Lazim
