EL-23O‘rtaPremiumTranzistor sxemalari
Logic Gates with Transistors: NOT, NOR and NAND
Build what is inside a logic gate IC yourself with two BC547s. Two buttons are the inputs A and B, and the LED shows the output Y: if the LED is on, the output is 1. By moving two jumper wires you turn the same circuit into a NOT, NOR or NAND gate: one transistor inverts, two side by side make a NOR, and two stacked make a NAND. You fill in the truth table of each gate with your own fingers.
0.0(0)

It is built with a 5 V supply, two BC547s, four 10 kΩ and two 470 Ω resistors, two buttons and a red LED. The output Y is pulled up to 5 V through 470 Ω; the LED sits between Y and GND and lights when Y = 1. When a transistor turns on, it pulls Y down to about 0.1 V. Two jumper wires named J1 and J2 select the gate: one transistor is a NOT, two transistors in parallel are a NOR, and two transistors in series are a NAND. What you learn: using a transistor as a switch, resistor-transistor logic (RTL), series and parallel connection, the truth table.
Premium kontent
Bu sxemaning o‘rnatish qadamlari, qanday ishlashi va ko‘p so‘raladigan savollari Premium a’zolar uchun ochiq.
- O‘rnatish qadamlari
- Qanday ishlaydi
- Ko‘p so‘raladigan savollar
