Arduino loyihalarini kashf qil
Boshlang‘ichdan yuqori darajagacha, sxemali, kodli va videoli yuzlab loyihalar. Qaysi darajada bo‘lsang, o‘sha yerdan boshla.

Raspberry Pi Pico Morse Code Translator (Button + OLED Display + Buzzer)
Tap the button and the Pico decodes your Morse! We are building a Morse code translator with a Raspberry Pi Pico that works like a telegraph key. A short press is a dot, a long press a dash; the buzzer beeps along and the OLED display shows each decoded letter in large type. A second button plays your text back in Morse, so you see both directions.

Raspberry Pi Pico Binary Clock (6 LEDs + Button)
This clock has no digits! We are building a clock with a Raspberry Pi Pico that shows the time in binary. The 6 LEDs are the 32-16-8-4-2-1 places; add up the lit ones and you read the seconds, minutes or hours. A single button switches fields and sets the time, and a light sweep runs across the LEDs every full hour.

Raspberry Pi Pico Tea Thermometer (DS18B20 + TM1637 + Buzzer)
Let the Pico tell you when your tea is ready to drink! We are building a thermometer with a Raspberry Pi Pico that measures the tea in your glass. A waterproof DS18B20 probe goes into the tea, and a TM1637 display shows the temperature and the time left until it is drinkable. At 65 degrees the buzzer plays a tune, and it warns you if the tea gets cold.

Raspberry Pi Pico Stopwatch (TM1637 + 2 Buttons + Buzzer)
Press, count, take a lap! We are building a stopwatch with hundredths on a Raspberry Pi Pico. The TM1637 display shows seconds and hundredths below one minute, then minutes and seconds. The START button starts and stops it, the LAP button takes a lap: LAP1 and that lap's time appear while the count keeps running. On reset the best lap is shown, and a buzzer confirms every action with a short beep.

Raspberry Pi Pico Digital Spirit Level (MPU-6050 + OLED Display)
Shelf up, but is it straight? We are building a digital spirit level with a Raspberry Pi Pico. The MPU-6050 measures gravity, and the OLED shows a bubble in a bullseye plus the X / Y tilt. Stand the board on its edge and the display turns into a classic tube level. Below 0.5° the display lights LEVEL, and just like a real one, the bubble drifts to the higher side.

Raspberry Pi Pico IR Remote Control for an LED and a Relay (IR Receiver + Relay + LED)
Turn the light on with a remote! We are building a remote-controlled LED and socket with a Raspberry Pi Pico, an IR receiver and a relay. 1 toggles the relay, 2 the LED; + and − change the LED brightness in 5 steps, PLAY starts a breathing mode and 3 runs the relay on a timer. NEC codes are decoded without a library, from pulse times measured with an interrupt.

Raspberry Pi Pico PIR Motion Alarm (PIR Sensor + Buzzer + LED)
Walk in once and you get a warning, walk in again and the siren goes off! We are building a two-stage motion alarm with a Raspberry Pi Pico and a PIR motion sensor. It arms itself after a countdown. The first motion plays a ding-dong warning on the buzzer; a second motion within 15 seconds sounds the siren and strobes the LED. Afterwards it re-arms on its own and logs every event with a timestamp.

Arduino Tilt Arrow (MPU-6050 + MAX7219 8x8 LED Matrix)
Tilt the circuit and the arrow turns to follow! We are building a tilt arrow that points downhill with an Arduino, an MPU-6050 accelerometer and a MAX7219 8x8 LED matrix. The arrow turns in 8 directions, grows as the tilt increases and blinks when it gets very steep. When the circuit is level, a pulsing level sign appears, and the angle and direction are printed to the serial monitor too.

Arduino Hourglass (2x MAX7219 8x8 LED Matrix + MPU-6050)
The sand is not real, but flip it and it runs back! We are building a digital hourglass with an Arduino, two MAX7219 8x8 LED matrices and an MPU-6050. Grains in the upper bulb drop one by one through a narrow neck and pile up below. Flip it and the sand flows back, lay it flat and it pauses; when time is up, the lower bulb blinks.

ESP32 Color Drawing Tablet (ILI9341 + Joystick + Buttons)
Push the joystick and draw! We are building a small drawing tablet with an ESP32 and a 2.8 inch ILI9341 color display. The joystick moves the cursor faster the further you push it, and four buttons lift the pen, change the color (8 colors + eraser) and brush size, and clear the canvas. In mirror mode every stroke is copied to the other side, so hearts and butterflies draw themselves.

Raspberry Pi Pico Alarm Desk Clock (DS1307 + TM1637 + Buzzer)
A desk clock that keeps time even through a power cut! The Raspberry Pi Pico reads the time from a battery-backed DS1307 real-time clock, and a TM1637 display shows hours:minutes with a blinking colon. When the alarm time comes, the buzzer plays double beeps and the display pulses; one button snoozes it for 5 minutes. The alarm lives in the DS1307's battery-backed memory, and the display dims itself at night.

ESP32 microSD Temperature and Humidity Logger (DHT22 + ILI9341 Graph)
Log the temperature of a room, greenhouse or fridge all day long! An ESP32 measures temperature and humidity with a DHT22 every 2 s and writes each reading to a CSV file on a microSD card. The ILI9341 color display shows live values, min and max, and a two-color live graph of the last 30 readings. Plug the card into your computer and open the file in Excel.
