The CR2032 battery holder is a small holder that lets you connect a 20 mm coin cell to your circuit without soldering the cell. You slide the cell in under the metal clip on top with the positive side facing up; the clip touches the positive terminal and the metal contact on the base touches the negative terminal. The holder has two pins, and its body usually has a plus mark; before soldering, check with a multimeter which pin is positive. It is soldered onto perfboard and PCBs; the pin spacing changes from model to model, so not every model fits a breadboard. It is used for backup power in clock modules, low-current sensor circuits and small LED projects. Do not use metal tweezers to remove the cell: if the tweezers touch both faces at once, they short-circuit the cell. The current the cell can supply does not change with the holder; a CR2032 still powers only loads of a few milliamps. The thinner CR2025 and CR2016 have the same diameter, but they can sit loose in this holder and cause poor contact.

