LM3914 LED Bar Driver
Components

LM3914 LED Bar Driver

0.0(0)
The LM3914 is an 18-pin (DIP-18) driver chip that measures the voltage on its input and lights 10 LEDs as a bar or as a single dot. Inside are an adjustable 1.25 V reference, a 10-step voltage divider and 10 comparators; each time the voltage rises by one step, one more LED lights. The scale is linear: with the reference used directly, each LED stands for about 125 mV. It runs from a single supply between 3 and 18 V, so a 9 V battery feeds it easily. The LED outputs are current-regulated, so the LEDs need no resistors of their own: one resistor between REF OUT (7) and REF ADJ (8) sets the current of every LED, roughly ILED ≈ 12.5 / R (R in kΩ, current in mA), adjustable from 2 to 30 mA. Pins: 1 LED1, 2 GND, 3 positive supply, 4 RLO, 5 SIG (input), 6 RHI, 7 REF OUT, 8 REF ADJ, 9 MODE, 10 to 18 LED10 down to LED2. Tie MODE to the positive supply for bar mode, leave it open for dot mode. LED anodes go to the positive supply, cathodes to the outputs. The input reads from GND up to 1.5 V below the positive supply and survives up to ±35 V.