Reed Switch (Glass Tube)
Components

Reed Switch (Glass Tube)

0.0(0)
A reed switch is a two-leg, magnet-operated switch made of two thin metal blades sealed inside a small glass tube. In the normally open (NO) type the blades do not touch, so the circuit is open; when you bring a magnet close, the blades become magnetised, pull each other together and the contact closes, and it opens again when you move the magnet away. It has no polarity and produces no voltage by itself: connect one leg to GND and the other to the positive rail through a pull-up resistor, and that point drops to GND when the contact closes. Held parallel to the tube, the magnet works from farther away; the distance depends on the magnet and the reed. Common 14 mm models switch at most 0.5 A and 10 W, with a contact resistance below 0.1 Ω; do not run loads such as motors or relay coils directly through the reed, use a transistor. The glass breaks easily: do not bend the legs closer than 3 mm to the body, and hold the leg with pliers next to the body while bending. This is the bare part, not the reed module with a comparator and a trimmer.