AR-156BeginnerPremium
Arduino Model Railway Turnout and Signal Remote (IR + 2 Servos + 4 LEDs)
Throw the two turnouts of your model railway with a TV remote: two SG90 servos move the point blades slowly, just like real points, and each turnout has a red/green signal. While a turnout moves its signal shows red, once it locks in place it turns green. 1 sets the main line, 2 the siding, and the turnouts move one after the other; the arrow keys switch a single turnout and POWER is an emergency stop. Positions are kept in EEPROM, so the servos do not jump at power-up.
0.0(0)

Run the train set under the tree with a remote: press a key and the turnouts swing over slowly one after the other, sending the train from the main line onto the siding. A small signal next to each turnout shows red while it moves and green once the road is set. An emergency stop makes the reds flash, so your layout works like a real station.
Source Code
Premium Content
The source code, block version and FAQ of this project are open to Premium members.
- All Project Code
- Block version
- Frequently Asked Questions
