ES-85IntermediatePremium

ESP32 Wi-Fi Plant Watering: Waters When the Soil Dries, Tells Your Phone (Soil Moisture Sensor + Relay + Pump + LCD + ntfy)

Automatic plant watering with an ESP32: the soil moisture sensor is turned into a percentage, and when it drops the relay runs the pump in short pulses, waits for the water to soak in and measures again. A float switch locks the pump when the tank is empty, and a daily limit prevents flooding. After every watering your phone gets "Bitki sulandi (nem %28 -> %65)"; watering keeps going even without Wi-Fi.

0.0(0)
ESP32 Wi-Fi Plant Watering: Waters When the Soil Dries, Tells Your Phone (Soil Moisture Sensor + Relay + Pump + LCD + ntfy)
Your plant won't go thirsty while you're on holiday. When the soil dries out, the pump waters in short bursts, waits for the water to spread, measures again and stops at the target moisture; if the tank is empty the pump never runs. The display shows the moisture and the last watering, and your phone hears about every watering and about an empty tank. Relay note: This board runs on 3.3 V. Use a relay module with an optocoupler that can be triggered by a 3.3 V signal; 5 V modules without an optocoupler may not switch off with a 3.3 V signal.

Source Code

Premium Content

The source code, block version and FAQ of this project are open to Premium members.

  • All Project Code
  • Block version
  • Frequently Asked Questions