ES-89IntermediatePremium
ESP32 Wi-Fi Water Heater Temperature Control: Phone Alert When the Hot Water Is Ready (DS18B20 + Relay + LCD + ntfy)
Water heater temperature control with an ESP32: a DS18B20 measures the water and a relay switches the heater on at target − 3 °C and off at the target. ECO, NORMAL and SHOWER modes plus + and − buttons set the target, and your phone gets a "su hazir" (hot water ready) alert. Overheating, a dead sensor or a heater that won't heat cut the relay at once. 230 V warning: the relay drives a contactor; a breaker, an RCD and a licensed electrician are a must.
0.0(0)

Check your phone before the shower and know whether the hot water is ready. When the water in your tank or instant water heater reaches the temperature you chose, the heater switches off and your phone gets a message; if the water overheats, the sensor goes silent or the heater stops heating, the circuit cuts the heater and sounds an alarm. The display shows the water temperature, the mode and the target.
Relay note: This board runs on 3.3 V. Use a relay module with an optocoupler that can be triggered by a 3.3 V signal; 5 V modules without an optocoupler may not switch off with a 3.3 V signal.
Source Code
Premium Content
The source code, block version and FAQ of this project are open to Premium members.
- All Project Code
- Block version
- Frequently Asked Questions
