EL-65IntermediatePremiumCounter circuits

2-Bit Counter: Count from 0 to 3 with the 74HC74

Connect two flip-flops in a chain to build a counter that counts from 0 to 3. In this 74HC74 circuit, each slide of the switch to the 1 position gives a pulse: the green LED shows the 1s place and the red LED the 2s place, so the count goes 00, 01, 10, 11 and starts again. This asynchronous (ripple) counter is a basic building block of digital clocks and frequency dividers.

5.0(1)
1 completed
2-Bit Counter: Count from 0 to 3 with the 74HC74
It is built with a 5 V supply, two 74HC74 ICs, one slide switch, four resistors and two LEDs. The two flip-flops in U2 work in T mode; since the second takes its clock from the first flip-flop’s Q̄ output, this is an asynchronous (ripple) counter. U1 cleans up the switch bounce and produces the clock pulse. What you learn: binary counting, the 2-bit counter, the difference between asynchronous and synchronous counters, frequency division, reading a timing diagram and preventing switch bounce.

Premium Content

This circuit's build steps, how-it-works guide and FAQ are open to Premium members.

  • Build Steps
  • How It Works
  • Frequently Asked Questions