EL-42AdvancedPremium555 timer circuits
Servo Tester with a 555: Angle Control with a Pot
Turn the pot and the servo arm follows it. The NE555 produces a pulse about every 19 ms, and the pot sets its length: at 1.1 ms the arm goes to one end, at 2 ms to the other. Two 1N4148 diodes separate the charging and discharging paths; because the pot is shared between the two paths, the period does not change while the pulse gets longer. The SG90 needs 4.8 to 6 V, so the circuit is powered with 5 V from the MB102.
0.0(0)

It is built with the MB102 module, one NE555, one SG90 servo, a 10 kΩ pot, two 1N4148 diodes, two resistors and three capacitors. The NE555 runs in astable mode and produces low-duty pulses; the servo reads the length of this pulse and moves its arm to that angle. What you learn: the servo signal, separating the charging and discharging paths with diodes, a constant period and the current spikes of a servo.
Premium Content
This circuit's build steps, how-it-works guide and FAQ are open to Premium members.
- Build Steps
- How It Works
- Frequently Asked Questions
