EL-89IntermediatePremium555 timer circuits

Earthquake Alarm: A Circuit That Sounds When Shaken

Tap the table lightly: the buzzer sounds, the LED lights and after about 3.5 seconds the circuit goes silent by itself. A vibration sensor with a thin spring inside picks up the shaking; an NE555 in one-shot (monostable) mode holds the time. The sensor's contact lasts only the blink of an eye, and the 555 stretches it into a warning that lasts seconds. This is not an earthquake warning system; it is an educational circuit that announces shaking.

0.0(0)
Earthquake Alarm: A Circuit That Sounds When Shaken
It is built with a 9 V battery, one NE555, four resistors, two capacitors, one LED, one active buzzer and one SW-18010P spring vibration sensor. The sensor sits between the trigger input (pin 2) and GND; a 10 kΩ resistor keeps the input from floating. When the table shakes, the input drops to GND and the output stays high for 1.1 × 68 kΩ × 47 µF ≈ 3.5 seconds. The LED is driven through 470 Ω and the buzzer through 100 Ω. What you learn: the monostable 555, the trigger threshold, the pull-up resistor and the RC time calculation. Do not rely on this circuit for anyone's safety; it is for learning only.

Premium Content

This circuit's build steps, how-it-works guide and FAQ are open to Premium members.

  • Build Steps
  • How It Works
  • Frequently Asked Questions