EL-39IntermediatePremium555 timer circuits
PWM LED Dimming: Brightness Control with a 555 and a Pot
Turn the pot and three LEDs go from almost off to fully bright. The NE555 switches on and off about 1200 times per second; the pot and two diodes keep the frequency almost constant while changing the share of each cycle it stays on, the duty, between about 4% and 95%. The LEDs always light with the same current, and your eye sees the average. This method is called PWM.
0.0(0)

It is built with a 9 V battery, one NE555, a 100 kΩ pot, two 1N4148 diodes, five resistors, two capacitors and three LEDs. The NE555 runs in astable mode. The middle leg of the pot is connected to pin 7; one side of the pot forms the charging path through D1, and the other side forms the discharging path through D2 and R2. When you turn the pot, whichever time gets longer, the other gets shorter by the same amount, so the total time hardly changes. What you learn: PWM, duty, average current and how the eye perceives brightness.
Premium Content
This circuit's build steps, how-it-works guide and FAQ are open to Premium members.
- Build Steps
- How It Works
- Frequently Asked Questions
