EL-32IntermediatePremium555 timer circuits
One-Button On/Off: Press to Light, Press to Switch Off with the 555
Press the button once and the LED lights; press again and it goes out. It works like a single-button lamp switch. The two inputs of the NE555 are joined and held at half the supply; a 1 µF capacitor remembers the last state of the output. When you press the button, this capacitor is connected to the input and pushes the 555 to the opposite state. The same capacitor also filters switch bounce: one press, one change.
0.0(0)

It is built with a 9 V battery, one NE555, one button, four resistors, two capacitors and an LED. Pin 2 and pin 6 are joined; two 10 kΩ resistors hold them at 4.5 V. The output charges the 1 µF C1 to its own level through 100 kΩ. When you press the button, C1 is connected to the input: if the output is high, the threshold is crossed and the LED goes out; if it is low, the trigger acts and the LED lights. What you learn: toggle logic, the two comparators of the 555, state memory with a capacitor and switch bounce.
Premium Content
This circuit's build steps, how-it-works guide and FAQ are open to Premium members.
- Build Steps
- How It Works
- Frequently Asked Questions
