EL-88BeginnerPremium555 timer circuits

Steady Hand Game

Take the loop along the winding wire from end to end without touching the wire. Touch it and the buzzer sounds and the LED lights, and they stay on even if you pull the loop away: the circuit remembers the touch. Press the button to start again. The memory is an NE555 in bistable mode, which catches even the shortest contact. You bend the track yourself from bare copper wire: tighter bends make a harder game. As you test your steady hand, you also see SET and RESET logic.

0.0(0)
Steady Hand Game
It is built with a 9 V battery, one NE555, four resistors, one capacitor, one LED, one active buzzer, one push button and 30 to 40 cm of bare copper wire. The bent wire is connected to GND and the loop to the trigger input of the 555 (pin 2); a 10 kΩ resistor keeps the input from floating. A contact sends the output high, and the output stays that way until the button pulls the reset input (pin 4) to GND. The LED is driven through 470 Ω and the buzzer through 100 Ω; about 38 mA in total. What you learn: the bistable 555, SET and RESET, the pull-up resistor, the output current calculation and building a simple game rig.

Premium Content

This circuit's build steps, how-it-works guide and FAQ are open to Premium members.

  • Build Steps
  • How It Works
  • Frequently Asked Questions